44GN054 is a two-component, fast dry, water reducible, chemically cured, high solids, epoxy-polyamide primers that is suitable for application on aircraft and aerospace equipment. Component A contains the pigment and polyamide resin. Component B is a clear, no pigmented epoxy, which acts as a hardener or curing agent for Component A. When this epoxy primer is used over properly prepared substrates, it provides a corrosion inhibiting, chemical and solvent resistant film suitable for topcoat. The cured primer is resistant to immersion in water, jet fuels, lubricating oils and hydraulic fluids.
Unit of Measure

Typical Characteristics (Before Reduction)

Mix Ratio by Volume

N/A 2 parts base to 1 part catalyst

Reducer by Volume

N/A Up to 4.5 parts of Distilled or Deionized Water

Induction Time

N/A No Induction Necessary

Recommended Dry Film Thickness

N/A 0.8 to 1.3 mil

Initial Mixed Viscosity at 77 Degree Fahrenheit (ºF) Temperature (# 2 Zahn Cup)

N/A 20 ± 2 seconds

Mixed Theoretical Weight Per Gallon

N/A 11.4 lb/gal

Tolerance for Mixed Theoretical Weight (±)

N/A 0.5

Mixed Theoretical Percentage (%) Solids by Weight

N/A 75.3 %

Mixed Theoretical Percentage (%) Solids by Volume

N/A 61.4 %

Theoretical Coverage at 1 Mil Dry Film Thickness

N/A 985 ft²

Pot Life at 77 Degree Celsius (ºC) ± 5 Degree Fahrenheit (ºF) Temperature

N/A 3 hour

Maximum Coatings Volatile Organic Compounds (VOC) Volume

N/A 340 g/L2.8 lb/gal

Note for Typical Characteristics

N/A Characteristics are calculated based on product formula and raw material characteristics reported by suppliers. Values are thought to be representative, but they are not to be treated as specifications.

Specifications

Shelf Life

N/A 1 year from DOM when stored between 35 ºC to 115 ºF in original, unopened containers away from direct sunlight.
Dry Times1 N/A Dry to Stack: Allow panels to air dry under standard conditions for 90 minutes before stacking.
Application Recommendations2 N/A May be applied by Conventional, Airless, Air Assisted Airless, HVLP or Electrostatic spray equipment.

Clean Up

N/A While still liquid, flush with water. Use IS-248 Cleaning Solvent for Water Reducible Primers to remove residual primer from parts and equipment.

Health, Safety, Storage and Handling

N/A Refer to the MSDS for each component.

Color

N/A DN 9295 Green
  • 1 77º ± 5 ºF, 50 ± 10% RH, 0.8 - 1.3 mils
  • 2 Additional set up or equipment may be required.